Fisher & Paykel AU SG User Manual download pdf (Page 21)

Rinse aid

We highly recommend the regular use of liquid rinse aid to give the best drying results. Rinse

aid gives a streak-free, sparkling clean look to glass and chinaware. In addition it prevents metal

from tarnishing. The rinse aid dispenser is located on the inside panel of the door.

Filling the rinse aid dispenser

Open the dispenser by turning the cap in an anticlockwise

direction.

Pour the rinse aid into the dispenser, making sure not to

overfill.

Take care not to spill rinse aid into the dishwasher. Any spills

must be wiped up to prevent excess foaming. Failure to wipe

up rinse aid spills may result in a service call, which will not

be covered by warranty.

Fit the cap back in the original position.

How much rinse aid to use

The dose regulator may need to be adjusted to suit your

water conditions. Regulate the amount of rinse aid by turning

the dose regulator, using a screwdriver. The dose regulator is

located underneath the rinse aid cap.

There are six dosage settings; the lowest setting is ‘1’ and

the highest setting is ‘6’. The normal dosage is setting ‘1’. If

there is excessive foaming at the end of the wash, reduce the

setting. If dishes are wet or streaky after drying, increase the

setting.

Rinse Aid indicator light

When the rinse aid level becomes low, the Rinse Aid indicator

will light up to remind you to refill the rinse aid. The Rinse Aid

indicator light can be found on the detergent dispenser cover

for all models, and on the exterior control panel

for models DW60CDW2 and DW60CDX2.

Fig. 7 Opening the rinse aid dispenser

Fig. 8 Adjusting the dose regulator

Fig. 9 Rinse Aid indicator light

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

No comments

Fisher & Paykel AU SG User Manual Page 21