Fisher-paykel RF610A User Manual download pdf (Page 29)

Water filter

All the water to your fridge is filtered to remove impurities through a cartridge located

in a position of your choice outside the refrigerator. Of course, this will need changing

approximately every 6 months or once 2800 L (740 gallons) of water has been dispensed,

depending on the quality of the incoming water and how much you use the dispenser.

There is a replacement indicator icon

on the control panel which will appear when the filter

needs replacing. It will flash, as a reminder, when water is dispensed.

Replacement cartridges are available from your authorised Fisher & Paykel Dealer. The details of

the replacement cartridge are on the label on the cartridge.

Changing the water filter cartridge

It is not necessary to turn off the water supply before attempting to change the water filter

cartridge.

Grasp and firmly twist the cartridge in an anticlockwise direction (to the left when installed in

the recommended orientation) as shown in Diagram 1.

Pull the cartridge away from the filter head (down when installed in the recommended

orientation) as shown in Diagram 2.

– It is not unusual for a few drops of water to be present when the filter is removed.

Discard old filter.

Filter installation:

– Remove protective cap on spigot on head.

– Push the cartridge up towards filter head while rotating it in a clockwise direction (to the

right when installed in the recommended orientation) as shown in Diagram 3.

Reset filter indicator icon on the display (this will remind you when the filter is due to be

replaced again). Refer to page 28.

Dispense 10 L (10 qt) to flush the cartridge, removing trapped air and harmless carbon fines.

A few drips may appear out of the dispenser over the next few days as the remaining trapped

air is cleared.

Diagram 2Diagram 1 Diagram 3

Fig.25 Changing the water filter cartridge

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 51 52

No comments

Fisher-paykel RF610A User Manual Page 29