Fisher-paykel V3 DS603 User Manual

RINSTALLATION INSTRUCTIONS(NOTE: FOR INTEGRATED PANEL PREPARATION INSTRUCTIONS REFER TO SUPPLIED SHEET)part number 526607 N 05/2005(page 1 of 12)US CA

Attach the Drain Hose Support to the cabinetry (with the screw supplied) to prevent siphoning and to keep the drain hose(s) from kinking. If required

On the chosen groove cut down the vertical ribs at the centre and the ends using a knife. Cut along full length with a knife. Turn Toe Kick over, ben

RINSTALLATION INSTRUCTIONS Be sure product is level, securely fastened to the cabinetry and opens and closes freely. The DishDrawer® must be free

BEFORE YOU START - DOUBLE & SINGLE MODELSPARTS SUPPLIEDDOUBLE MODELSDrain Hose Support (1)Drain Hose Joiner (1)Wire Clips (2)Installation Tabs (2)

DOUBLE MODELSSERVICES SPECIFICATIONSTOE KICK DEPTHPrefinished & Flat Door 2”-43/8” (50-110mm); Integrated 5” (127mm) less the Toe Kick Panel thick

MAX height to top of AIR BREAK(countertop or wall-mounted)37 3/8” (950mm)DOUBLE MODELSPLUMBING OPTIONSOPTION 1DishDrawer® and Standpipe Ø11/2” (38mm)

WATER CONNECTIONRecommended HOT (Maximum 140°F/60°C). Supplied hose to suit 3/8”(9mm) male compression fitting.WATER SOFTENER MODELSRefer to your Dis

SINGLE MODELSOPTION 1DishDrawer® and Standpipe Ø11/2” (38mm) with Air Gap.OPTION 2DishDrawer® with Waste Disposal.MAX height to top of AIR BREAK(count

PLEASE NOTE: Your model of DishDrawer® may differ from the model shown in the installation diagrams. Installation is similar for all models for either

SINGLE MODELS ONLY Check the position of the chassis is still where marked on the cavity, before securing the product. There are four 5/8” (16mm

RINSTALLATION INSTRUCTIONSSTEP 5: ELECTRICAL CONNECTION To refit the tub, make sure both of the latches at the rear of each drawer runner are facing