Fisher-paykel MR810 User Manual download pdf (Page 26)

MR810 Technical Manual Rev C REF 185042601

6.5.6 REPLACING THE HEATER PLATE ELEMENT

NOTE: The correct heater plate element is required (refer to Table 9 below).

1. Open the case and remove the PCB (§ 6.2).

2. Remove the heater plate (§ 6.5.2).

3. Cut the cable ties attached to the heater plate harness.

4. Unscrew the six screws holding the backing plate and remove it (Figure 6.8). Refer to Figure 8.2 for

the exploded diagram.

5. Check the heater plate resistance against Table 9. Discard the heater plate element if the resistance is

incorrect (do not d iscard the mica insulato r situated under the heating element).

6. Inspect the mica insulator for any holes by holding it up to the light, and replace it if any are visible

(part number 331 040 114).

7. Ensure the mica insulator is correctly located on the heater plate and place the new element and

backing plate over the top.

8. Screw the heating element backing plate back on with the six screws.

9. Clip three small cable ties (2.5 mm wide) around the heater plate harnesses. Place one close to the

heater plate, securing all wires as they protrude through the top case. Place the second tie halfway up

the wires securing the heater plate harness and protective earth wire (leave the thermistor wires free for

flexibility in connecting to the PCB). The last tie secures th e heater plate harness wires near the Molex

plug. (Refer to Figure 6.7 for cable tie locations).

10. Install the heater plate back into the case top (§ 6.5.7).

11. Reassemble the PCB and the case (§ 6.8).

Table 9: Replacement heater plate elements

Model Supply Voltage Heater Plate

Element

Part Number

Heater Plate

Resistance

(Cold)

MR810A-- 230 V~ 043 041 342

353 ± 12 Ω

MR810J-- 115 V~ 043 041 340

88 ± 3 Ω

MR810G-- 100 V~ 043 040 341

67 ± 2 Ω

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 42 43

Youssef Shaban 06 May 2024 | 07:56:51

Thanks

Fisher-paykel MR810 User Manual Page 26