Fisher Paykel DE4024P1 User's Guide download pdf (Page 15)

INSTALLATION INSTRUCTIONS

Connecting dryer using 4-wire connection (must be used for mobile home installation)

Note: since January 1, 1996, the National Electrical Code requires that new constructions

use a 4-wire connection to an electric dryer. A 4-wire cord must also be used where

local codes do not permit grounding through the neutral. 3-wire connection is NOT for

use on new construction.

Cover

Green wire from

power cord

3/4” Strain relief

and bracket

4 #10 AWG minimum copper conductors or 120/240V 30A power supply cord kit

marked for use with dryers and provided with closed loop or spade terminals with

upturned ends (not supplied)

Turn off the circuit breaker(s) (30 amp) or remove the dryer’s circuit fuse at the

electrical box.

Be sure the dryer cord is unplugged from the wall receptacle.

Remove the power cord cover located at the upper back.

Remove green ground screw and retain for use in Step

. Remove center screw

(markedN) in terminal block. Remove and discard ground strap.

Install 3/4 in. UL-recognized strain relief to power cord entry hole. Bring power cord

through strain relief and bracket.

Connect power cord as follows:

A. Connect the 2 hot lines to the outer screws of the terminal block (marked L1 and L2).

B. Connect the neutral (white) line to the center of the terminal block (marked N).

Attach ground wire of power cord with the green ground screw (hole above strain relief

bracket). Tighten all terminal block screws (3) securely.

Properly secure power cord to strain relief and bracket.

Reinstall the cover.

IMPORTANT!

Never leave the cover off of the terminal block.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 83 84

No comments

Fisher Paykel DE4024P1 User's Guide Page 15