Important! SAVE THESE INSTRUCTIONSThe models shown in this document may not be available in all markets and are subject to change at any time. For
The following calculations assume the top of the panel is aligned with the top of the adjacent cabinetry:width of the panelMeasure A (the width betwee
PARTS SUPPLIEDZONE REQUIRED FOR BADGE REMOVE PANEL BRACKET & DETACH BADGE345Panel mounting screws (14)Supplied separately Attached to productInteg
ROUTE BADGE THROUGH PANELRECONNECT BADGE REATTACH PANELSECURE PANEL BRACKET TO PANEL68971212⁄” (16 mm) x1412Electrical Shock HazardWARNING !Connect
If, after installation, the front panel of your DishDrawer is not correctly aligned with the front panels of surrounding cabinetry, it can be adjusted
DETACH CONTROLS LOOSEN PANEL BRACKETSREMOVE FRONT PANEL4532DISCONNECT FROM POWER SUPPLYElectrical Shock HazardWARNING !Disconnect the DishDrawer from
SLIDE BRACKETS TO SUITABLE HEIGHT SETTINGRECONNECT CONTROLS REATTACH PANELTIGHTEN PANEL BRACKETS689712Electrical Shock HazardWARNING !Connect the grou
RECONNECT THE POWER SUPPLY10www. sherpaykel.com www. sherpaykel.ca www. sherpaykel.co.nz www. sherpaykel.com.au www. sherpaykel.co.uk www.
Comments to this Manuals