Fisher Paykel DD24DCTX9N Installation Manual download pdf (Page 11)

!1-A SECURE TO THE CABINETRY ON THE SIDES !2-A OPTIONALLY SECURE TO THE CABINETRY ABOVE

Open the

drawer halfway.

Using a flat

bladed

screwdriver,

prise the gray

rubber plug out

of the trim

moulding.

Replace the gray

rubber plug back into

the trim moulding

and ensure the trim

seal is facing forward.

Repeat for all

four brackets.

Using a small

Philips screwdriver,

screw through the

trim moulding,

securing the side

mounting bracket

to the cabinetry.

Do not damage

the rubber

trimseal.

(x2)

The top mounting

brackets will only

bend upwards a

maximum of 3/8”

(10 mm).

!3-A FIT THE SUPPLIED TOEKICK PANEL

IMPORTANT!

Do not overtighten screw.

Where the toekick

meets the bottom

of the tub is the

cut-off point

Mark this point on the

toekick with a pencil

Lay the toekick face down on

a chopping board or similiar

Smooth the edge with a file.

Be careful of sharp edges.

Snap off the two end tabs

Slide the toekick onto

the mounting rails

either side and screw

the toekick onto the

bottom of tub on

either side.

Mounting rail

Score along the marked

cutoff line with a knife

Turn the toekick over and

score along the same line

Gently snap off the excess

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Comments to this Manuals

No comments

Fisher Paykel DD24DCTX9N Installation Manual Page 11

Comments to this Manuals

Related products and manuals for Unknown Fisher Paykel DD24DCTX9N