Fisher Paykel DD24DCTX9N Installation Manual download pdf (Page 5)

3 OPTIONALLY HARD WIRING PRIOR TO INSTALLATION

IMPORTANT!

Ensure the mains wires are routed

UNDERNEATH all other harness

wiring from the electronics module.

3-D REFIT THE DRAWER ONTO THE RUNNERS & CLOSE

3-C TERMINATE MAINS WIRING AS SHOWN AND REPLACE MODULE AND COVERS

4” (100 mm)

Pull the release tabs forward on both

sides 4” (100 mm). Ensure the tabs are

fully pulled forward and click into place.

8 Fit a suitable cable clamp for the

conduit through the metal knockout.

Ensure wiring is routed through or

under under housing ribs.

9 Screw down the Live, Neutral and

Earth wires correctly.

10 Push the plastic harness cover back

over. It should clip back into place

11 Fold down and slide back the

terminal block cover.

12 Refit the electronics module back

into position, being careful of wiring.

13 Replace the screw securing the

electronics module.

14 Slide the access cover back,

ensuring the 2 clips shown are fully

locked in place.

NOTE: Use copper conductors

only.

Before refitting the

drawer, ensure the hoses

are not twisted and the

latches at the rear of

each drawer runner are

facing forward.

Lift or rotate counter-clockwise the

drawer back onto the drawer runners

on either side.

Release tab

1 2 3 4 5 6 7 8 9 10 ... 39 40

No comments

Fisher Paykel DD24DCTX9N Installation Manual Page 5