Fisher Paykel RS36W80LJ1N User Manual download pdf (Page 19)

8 84” (2134mm) CAVITY – ATTACH ANTI-TIP BRACKET

IMPORTANT!

Safety requires refrigerators be stable when door and/or drawer, are open. The anti-tip bracket and fittings supplied must be fitted to the wall of the finished enclosure to withstand

a220.5lb (100kg) load. This will prevent the possibility of the appliance tipping forward, when door and/or drawer, are open.

WARNING!

Failure to follow instructions can lead to serious injury or death.

When fastening with masonry plugs and/or screws:



Ensure the screws avoid electrical, gas and water conduits.



Ensure the surface the bracket is fastened to withstands a 220.5lb (100kg) load.



Ensure light-weight masonry material such as cinder block and new concrete (no curing time) are not used in installation.



Do not use metallic materials that may corrode, stain and/or damage the enclosure

23/8” min.

(60mm)

overlap

Bracket

PROFILE VIEW

Subtract 61/2” (164mm) from above

finished enclosure

23/8” min.

(60mm)

overlap

Bracket

PROFILE VIEW

Subtract 61/2” (164mm) from above

finished enclosure

Spacer

23/8” min.

(60mm)

overlap

Bracket

PROFILE VIEW

Subtract 61/2” (164mm) from above

finished enclosure

Spacer installation

If a minimum 23/8” (60mm) overlap cannot be achieved we recommend

fastening a solid spacer (wooden beam etc) behind the bracket.

Ensure the length of the spacer corresponds to the enclosure’s width. Always

secure the spacer to existing studs on the enclosure wall (refer toC).

Fix bracket to the spacer with screws x4 (#10 x 40 pan head Phillips screws).

Ensure screws hold tight and the bracket overlaps the appliance when it is

positioned (23/8”min. (60mm)) for a secure hold.

Solid wall installation

Project the end of the above finished enclosure to the center of the back wall and

subtract 61/2” (164mm). This will locate the contact surface between the bracket

and the appliance (refer toB).

Mark screw locations to drill Ø1/4” x 13/8” (Ø 6mm x 35mm) deep holes. Hammer

masonry plugs into the wall until flush x4. Fix bracket to the wall with screws x4

(#10 x 40 pan head Phillips screws). Ensure screws hold tight.

For 84” (2134mm) cavity installation

Wooden/plaster board wall installation

Project the end of the above finished enclosure to the center of the back wall and

subtract 61/2” (164mm). This will locate the contact surface between the bracket and

the appliance (refer toA).

Ensure a structural beam/wall stud closest to the center of the wall enclosure is located.

Fix bracket to the wall with screws x4 (#10 x 40 pan head Phillips screws).

Ensure screws hold tight and the bracket overlaps the appliance when it is positioned

(23/8” min. (60mm)) for a secure hold.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

Comments to this Manuals

No comments

Fisher Paykel RS36W80LJ1N User Manual Page 19

Comments to this Manuals