Fisher Paykel RS36W80LJ1N User Manual download pdf (Page 28)

!5 HANG NON-WATER DISPENSING DOOR PANELS

Once satisfied with all door panels, secure M8 studs

with M8 washer and M8 nut (refer to B). The top of the

stud must remain below the top face of the door panel.

Secure side bracket forks by tightening side screws (C).

Repeat this process for all door panels.

Note: for depth adjustment loosen side screws x4,

adjustpanels and then retighten oncesatisfied.

Note: further adjustment of door panels can be achieved by removing door panels

then loosening the fixing screws for the hanging bracket and moving the bracket

sideways to suit.

Loosely install locking bracket into the pocket on the underside of the door using a

M8 stud (D). Slide the locking bracket out until it touches the back of the door panel.

Screw in place using a #8 x 16 screw through one of the three slotted holes. Fully

tighten the M8 stud.

All door panels have full axis adjustment to ensure

they are flush with adjacent walls. To adjust the

height of each panel turn clockwise to raise stud or

counter-clockwise to lower stud (refer to A).

IMPORTANT!

Remove protective film from white product

doors before hanging door panels.

Hang all door panels onto M8 studs and align

the side bracket forks onto the refrigerator door.

– Ensure the forks are positioned around the

body of the side screws (M5 x 10 pan head

Phillips screw).

Push the product until the door panels are flush.

Depending on your installation design this will

be flush with your adjacent cabinetry or your

framework. Place a ruler on the front of the

product to check flushness top and bottom, left

and right (refer to drawing below).

Ensure the gap between the top of the door

panel and the top cabinetry is no greater

than 1/4” (7mm). To reduce this gap, raise the

product by turning all four adjustment nuts the

same number of turns.

IMPORTANT!

Failure to follow these steps can lead to

difficulties in door panel adjustment and

cosmetic cap fitment.

For Fisher & Paykel EZKleen stainless steel and DCS stainless steel door panels and custom panels.

Place a ruler on the front of

the product to check flushness

top and bottom, left and right.

Lock top panel side screw to allow

opening the door without affecting

adjustment.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 39 40

Comments to this Manuals

No comments

Fisher Paykel RS36W80LJ1N User Manual Page 28

Comments to this Manuals