Fisher Paykel OR30SDE6X1 Installation Guide download pdf (Page 10)

Fitting the adjustable feet

The adjustable feet must be fitted to the base of the range before use.

Rest the rear of the range on a piece of the polystyrene packaging exposing

the base for the fitting of the feet.

IMPORTANT

Take care not to damage the range during this operation.

Fit the four legs by screwing them tight into the support base as shown.

Levelling the range

●

The range may be levelled by screwing the lower ends of the feet IN or OUT.

●

Small adjustments may be made to the range in the upright position, however it

may be necessary to tip the range again to make larger adjustments.

Fitting the adjustable feet covers (optional)

If using the adjustable feet covers fit these while the range is tipped over.

!1FITTING THE ADJUSTABLE FEET

3 Note: gently bend the edges of the

inner cover to adjust the tension

between the two parts if needed.

4 Attach the feet covers to the base of

the range using the supplied screws.

Ensure that the mounting brackets

are aligned with the mounting holes

in the base of the range.

2 Assemble the feet covers by slotting

the inner cover inside the outer

cover.

5 Stand range back upright. 6 Adjust the inner panels of the foot

covers to suit the height of the

range feet as necessary.

1 Tip range onto its back to expose

foot cover mounting hole locations.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

No comments

Fisher Paykel OR30SDE6X1 Installation Guide Page 10